Get 50% Flat Discount | Limited Time Offer - Ends In 0d 00h 00m 00s Coupon code: 24NY50OFF

Home
Cisco
300-510 SPRI Exam Questions

Home ❯
Cisco ❯
300-510 SPRI Exam Questions

Free 300-510 SPRI Exam Questions - Cisco 300-510 Exam

Cisco 300-510 Exam

Implementing Cisco Service Provider Advanced Routing Solutions

Total Questions: 214

Last Updated : 10-11-2024

Get Premium Files

Cisco 300-510 Exam - Prepare from Latest, Not Redundant Questions!

Many candidates desire to prepare their Cisco 300-510 exam with the help of only updated and relevant study material. But during their research, they usually waste most of their valuable time with information that is either not relevant or outdated. Study4Exam has a fantastic team of subject-matter experts that make sure you always get the most up-to-date preparatory material. Whenever there is a change in the syllabus of the Implementing Cisco Service Provider Advanced Routing Solutions exam, our team of experts updates 300-510 questions and eliminates outdated questions. In this way, we save you money and time.

Cisco 300-510 SPRI Exam Sample Questions:

Q1.

Refer to the exhibit.

q1_300-510

Refer to the exhibit. MPLS traffic from 192.168.4.0/24 to 192.168.5.0/24 is failing to pass over the link from R4 to R2. The engineer verified that:

Cisco Express Forwarding Is enabled on all routers.

All routers reach all networks via OSPF.

MPLS traffic from 192.168.1.0/24 to 192.168.3.0/24 is passing normally over the link from R1 to R2.

Which action resolves the issue?

AOn router R4, remove the mpls ip command on the s/O/O/2 interface.

BOn router R2, configure the mpls ip command on the SIO/O/4 interface.

COn router R4, configure the mpls label protocol Idp command on all serial interfaces.

DOn router R2, configure the mpls label protocol Idp command on the interface.

Q2.

Refer to the exhibit.

q2_300-510

Refer to the exhibit. Company A established BGP sessions with several ISPs. A network engineer at the company must filter out all traffic except for routes that transit AS 152. The engineer configured the filtering policy ''permit _152S_(_[0.9])'' on R1, but after applying the configuration, the engineer notices that other routes are still visible. Which action resolves the issue?

q2_300-510

AOption A

BOption B

COption C

DOption D

Q3.

An ISP has an MPLS VPN-based network with 12 PE routers. How many peerings are required between the 12 routers if the engineer has not configured route reflectors?

A60

B66

C78

D84

Q4.

What is the purpose of ACL type prefix set entries in RPL prefix sets?

AThey hold IPv4 or IPv6 prefixes that do not match specifications.

BThey hold IPv4 or IPv6 prefix match specifications.

CThey hold IPv6 prefix match specifications.

DThey hold IPv4 prefixes that do not match specifications.

Q5.

Refer to the exhibit.

q5_300-510

Refer to the exhibit. A network engineer is configuring router R3 to handle multicast streams, but Host-2 cannot send subscriptions messages to the IPTV source. Which configuration must the engineer apply to router R3 so it passes the IPTV stream to Host-2?

q5_300-510